assign a port for internet sharing on mac

Assign A Port For Internet Sharing On Mac Computer Can

This link can be found towards the bottom of the Network and Sharing Center window.

To create this article, 19 people, some anonymous, worked to edit and improve it over time.

Luckily, your Windows or Mac computer can easily share its internet connection with the rest of the network.

You can even turn your computer into a wireless access point so you dont need a router to connect your wireless devices.

When sharing internet through your network, it will require a slightly different layout than a standard network.

If you are connecting a modem to the host computer via Ethernet, it will need two Ethernet ports (one to connect to the modem, and the other to connect to the hub or router).

Note that the connecting computers dont need any special settings, and can be running any operating system.

You can quickly open this window by pressing the Windows key R and typing kbdncpa.cpl.

Make sure that you are only performing these steps on the adapter that is actually connected to the internet, not the adapter that will be connecting the host to the rest of the network.

This is important if the other computers need to access email, FTP, or other special services.

Now that the host computer is set up, youll need to configure the router to allow it to pass the connection through.

Click here for detailed instructions on opening the routers configuration page.

Again, the wording will vary slightly depending on your exact router.

Your host and router have been configured, and now its time to connect your other devices.

You must have at least two different network adapters installed to use internet connection sharing.

This is typically caused by the computer not getting a correct IP address.

All of the other computers on the network should not have internet connection sharing enabled.

This should be the adapter that is connected to the internet and the adapter that is connected to the rest of the network.

This method will allow you to use an unused wireless adapter on your Windows host computer to broadcast a wireless network that any other device can connect to, just like a wireless router.

First, youll need to enable internet connection sharing on the host computer by following Steps 1-5 of the first section.

If the host computer doesnt have a wireless card installed, you can use a USB wireless adapter.

Dont enable internet sharing on the wireless adapter that youll be using to create the wireless network.

This will open a new window with your active network connections.

Assign A Port For Internet Sharing On Mac Computer Can